1/4in
4 × 4 inch structural steel tube, on every arm from two fixtures to fourteen.
PRO-ARM sports lighting cross-arms
Over-built,
on purpose.
Two to fourteen fixtures on a single arm of heavy structural steel — far stronger than almost anything else you can put on top of a pole.
- Made in the USA
- Build America, Buy America compliant
2–14Fixtures on one arm
1/4 inWall, 4 × 4 in steel tube
1 boltThru-bolted at every position
2 stylesTop mount or over/under
The interactive 3D model needs WebGL, which this browser has turned off. Everything else on this page works without it.
Finish Galvanized
Fixtures 6 fixtures
PRO-ARM 6
Mounting
View
Illustrative model. PRO-ARM cross-arms are drilled to suit the fixtures on your project.
Strength
Built for more than
it will ever carry.
Most cross-arms are made just strong enough. We went the other way: heavy structural tube, welded plate, and a bolt straight through the steel at every fixture.
3/8in
Bent plate, welded above and below the arm, bolted to the pole with four bolts.
5/8in
One at every position, through both walls of the tube. Fixtures are bolted on, not clamped on.
Structural tube
4 × 4 inch steel tube with a quarter-inch wall, the same section on every arm in the range.
Thru-bolted fixtures
A single 5/8-inch bolt through both walls at each position. On over/under arms it holds the fixture above and the one below.
Welded mounting clips
Clips bent from 3/8-inch plate, welded top and bottom at the centre of the arm, meet the cross-arm mount on the pole.
Wiring inside
A wire hole in the back wall at every position routes each fixture’s cable through the arm and into the pole.
Centre extension
Odd counts add a short extension at the centre, so the middle fixture sits ahead of the pole.
Finished to match
Hot-dip galvanized to ASTM A123, powder coated or painted — the same finishes as our poles.
American made. American proud.
Made in the USA.
Every Sequoia pole and PRO-ARM cross-arm is built in our own shop in Conroe, Texas — and complies with Build America, Buy America requirements.
Made in the USA.
Cut, formed, welded and finished by our own crew, under one roof, just north of Houston.
Build America, Buy America compliant.
Our products meet the Build America, Buy America (BABA) domestic-preference requirements that apply to federally funded infrastructure projects.
Ready for funded projects.
Schools, parks, municipal fields, transportation. Tell us it’s a Buy America project when you request a quote.
Configurations
Every count from
two to fourteen.
Pick one to see it in 3D. Odd counts carry their middle fixture on a short centre extension.
Top mount
Fixtures above the arm. Two to seven.
Over / under
Fixtures above and below, on the same bolt. Four to fourteen.
What it bolts to
The poles underneath.
Round Straight
10–30 ft
The clean, familiar profile for parking lots, pathways and site lighting.
- One-piece straight shaft
- Square anchor base with cover
- Side-drilled or tenon top
Round Tapered
20–120 ft
Height with grace. Area lighting up to sports and high-mast structures.
- Constant taper, base to tip
- Sectional for taller heights
- Direct embed or anchor base
Square Straight
10–40 ft
Crisp architectural lines, with flat faces that make mounting easy.
- One-piece square shaft
- Square anchor base with cover
- Side-drilled or tenon top